Stratix 5700 CLI Commands Using HyperTerminal For Boot Recovery | Stratix 5700 Will Not Boot

So your Stratix 5700 switch will not boot up, I understand & have been there so I made this video to show how to recover from that along with helpful tricks from Rockwell Tech notes. HyperTerminal was widely used in…

Stratix 5700 CLI Commands Using HyperTerminal For Boot Recovery | Stratix 5700 Will Not Boot

Source

0
(0)

So your Stratix 5700 switch will not boot up, I understand & have been there so I made this video to show how to recover from that along with helpful tricks from Rockwell Tech notes.

HyperTerminal was widely used in Windows XP & Windows 7 which now, a lot of people have started using PuTTY.

But there are limiting factors using PuTTY so I still use HyperTerminal on all of my Windows 10 machines.

Video Contents:
0:00 Talking about using HyperTerminal
2:35 Talking about the USB to Serial Adaptor & Setup
3:20 Setting The Baud rate of the USB to Serial Connection
5:10 TechNote about NOT BOOTING COMPLETELY
5:45 Using the CLI command in HyperTerminal
6:30 Note – If NO Boot Then You Will Not be Asked a password
7:10 Checking the Current Boot – Turn Off Manual Boot
9:41 Creating a Bootable SD card
13:45 Singing Into the Stratix 5700 Using Webpage
15:30 Syncing the IOS to the SD card for backup
16:30 Describing the recovery process the simple way
25:05 Important connection note about the video – Limit confusion
28:10 What the proper files look like on the SD card

Get the Boot Code: https://mmini.me/Join-Here

I hope you enjoyed the video.

Thank you for watching the video.

Learn, Implement, Succeed

If you are interested in getting serious about your knowledge & learning how to better your career then check out our training center.

Don’t forget https://mmini.me/Join-Here

#HyperTerminal #Stratix5700

0 / 5. 0